Pressure Testing Procedure
- Connect pressure gauge to hose bib outlet
- Open valve fully and record static pressure
- Record flow pressure with water running
- Compare readings to baseline measurements
- Check for pressure fluctuations or irregularities
- Document any significant pressure changes
Leak Detection Inspection
- Turn off all water flow and observe for drips
- Check around handle and packing nut when operating
- Inspect ground around hose bib for wet spots
- Look for mineral deposits indicating chronic leaks
- Check interior spaces if wall-mounted for water damage
- Use soap solution to detect small gas-like leaks
Freeze Protection Verification
- Locate and test operation of shutoff valve
- Verify drain valve functionality if present
- Check insulation coverage and condition
- Test frost-free mechanism by cycling valve
- Verify heat trace system operation (if installed)
- Review winterization procedures with staff
Water Quality Assessment
- Run water for 2-3 minutes to clear standing water
- Check water clarity and color
- Note any unusual odors or taste (if potable)
- Look for particles, rust, or debris in flow
- Compare with other water sources on property
- Document any quality concerns for follow-up
Monthly Maintenance
- Operate each hose bib to prevent valve seizing
- Check for new leaks or changes in operation
- Clear vegetation and debris from around faucets
- Verify drainage is working properly
- Check security of mounting hardware
- Test water quality and pressure
Seasonal Maintenance
- Spring: Check for freeze damage and restore service
- Summer: Verify adequate flow for irrigation needs
- Fall: Prepare winterization procedures
- Winter: Monitor frost-free operation in cold climates
- Adjust maintenance frequency based on usage patterns
- Service valves before heavy-use seasons
Annual Maintenance
- Disassemble and service valve components
- Replace washers, O-rings, and packing materials
- Check supply line for corrosion or damage
- Test and service anti-siphon devices
- Update freeze protection systems
- Document performance trends and plan upgrades
Emergency Winterization
- Shut off water supply at service valve
- Open hose bib and drain all standing water
- Remove any attached hoses and accessories
- Install insulation covers on exposed components
- Mark locations for spring reactivation
- Document winterization completion dates