Cutting Machines Calibration Checklist
This checklist is designed to assist in maintaining precision in cutting machines. The following procedures should be performed periodically to ensure best operating conditions and avoid downtimes. The steps include beam alignment for laser cutters, torch height setting for plasma cutters, pressure calibration for waterjets, and others. Use this checklist to keep your workflow efficient and maintain top-notch quality in your cuts.
Equipment Identification
▣ ID/Number:
▣ Hours/Mileage:
Operator Information
▣ Operator Name:
▣ Date:
Beam Alignment (Laser)
- ▢ Ensure that the laser is properly aligned
- ▢ Check the beam quality at the focal point
Torch Height Setting (Plasma)
- ▢ Verify the correct torch height
- ▢ Ensure clean and smooth cut surfaces
Pressure Calibration (Waterjet)
- ▢ Check for consistent pressure
- ▢ Ensure piping and seals are functioning properly
Motion System Verification
- ▢ Ensure linear motion system functions smoothly
- ▢ Check the system with slow, medium, and fast motion speeds
Material Support Check
- ▢ Check that material is properly secured
- ▢ Ensure no deviation in cut due to material movement
Cutting Parameter Optimization
- ▢ Verify optimal settings for speed, power, and gas pressure
Nozzle/Orifice Inspection
- ▢ Inspect the nozzle or orifice for wear or damage
- ▢ Ensure no obstruction or foreign material presence
Test Cut Evaluation
- ▢ Perform a test cut and evaluate
- ▢ Ensure the final cut meets quality standards
Defects
If any defect or issue is found, write a detailed report:
Operator acknowledgment
I, _________, certify that the above checks were performed to the best of my knowledge and belief.
Signature _______________ Date _______________
Access this checklist from any device, save your progress, and implement this checklist as part of your standard operating procedures.
Use This Checklist